Head

Correct installation of vertical slurry pump impeller

Correct installation of vertical slurry pump impeller


As we all know, the vertical slurry pump is a kind of vacuum pump used to transport various industrial liquids. This type of pump can also resist wear under corrosion resistance and can adapt to the environment. The installation of vertical slurry pump is very important. We should install it as required during installation to avoid abnormalities during use.

When we install the vertical slurry pump impeller, we should tighten the impeller cap and check whether the distance between the impeller and the pump body is about two millimeters. After installing the pump cover, check whether the gap between the pump cover and the impeller is about 2 mm, and the pump for warm medium requires a clearance of about 2.5 mm. During the installation process, if the gap between the vertical slurry pump impeller and the pump body is not required, it can be adjusted by increasing or decreasing the gasket between the vertical slurry pump impeller and the bushing. The gap between the pump cover and the impeller is not required, and can be adjusted by increasing or decreasing the gasket between the pump body and the pump cover.

Due to the usual production and use, vertical slurry pumps are often used to transport liquids such as strong acids and alkalis. Therefore, we must be careful when installing them. After installation, we should try them out so that we can use them normally. Will not cause trial failure